Well, here is the deal. I was rummaging through my shop when i came across two of these TS10.8 woofers from Treo, new in the box of course. I wanted to know how i should build this box for them.
Here are the T/S Parameters:
Mounting Hole: 9-3/16"
Mounthing Depth: 4-3/4"
Outside Diameter: 10-9/16"
RMS Power: 150W
Re DC Impedence: 8.0 ohm
Sensitivity: 85.26
V.C. Diameter 2.0"
Motor Strucutre: 114 Oz.
Le 7.98 mH
Vas: 2.26cuFt
Qts: .641
Qes: .715
Qms: 6.166
MMS: 100.66g
BL: 14.32 TM
Sd: .418 SQFt
X-MAX: .865"
Fs: 29.00 Hz
I hope all that helps. Someone design me a box. Make it simple enough for me to understand lol, i'm just the boss and my box guy is on vacation so i'm screwed for 2 weeks. Might as well keep busy. Just give me length x width x height.
-------------
"I don't play games. I play Nakamichi and that for real yo" - Probably some japanese kid said this in the early 80's trying to sell stereo out of his trunk lol.
I assume everyone is lost in the dark or not paying attention... Anyone want a flashlight?
- Someone said they needed T/S parameters to build a box, so let a rip.
Tony
-------------
"I don't play games. I play Nakamichi and that for real yo" - Probably some japanese kid said this in the early 80's trying to sell stereo out of his trunk lol.
It's not that hard to design or build one. Just download WinISD and play around with different box types and sizes. You probobly would want to put them in a ported box because of their low sensitivity.
WinISD www.linearteam.dk