Print Page | Close Window

Cavalier Audio Install

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=49060
Printed Date: October 31, 2024 at 6:25 PM


Topic: Cavalier Audio Install

Posted By: Jaay
Subject: Cavalier Audio Install
Date Posted: January 31, 2005 at 5:20 PM

Ok in a 2000 cavalier z24 we are putting an amp on the Stock Deck, We have the RF adapter but i need to know what 4 wires i hook up from the car to the adapter, or a site that would tell me this. Also on a 1995 Cavalier THe thick black wire that goes into the back of the deck , I think its ground, is broken in half  but there is white tube with copper wires inside of it and copper wires around the outside of it... how do i fix this?

Thanks



-------------
The Faster The BEtter



Replies:

Posted By: rallysport
Date Posted: January 31, 2005 at 6:24 PM
that black wire sounds like your antenna, should be wires inside the white tube and out side, youd have to solder on a new antenna plug by seperarting the 2. as for the rf adaper by the 4 wires i think your asking for the speaker level inputs, i am unsure of the wire colors for the 2000 cavalier but you could just open the trunk and look up at the rear speakers to find out the 4.

-------------




Posted By: white installer
Date Posted: February 01, 2005 at 6:30 AM

Yea, your antenna was cut... DOH!... and rallysport is right, look under the rear reck... if you take the clips off you will see A and B... it doesnt matter so much which one you hook up to the + or not... just make sure you keep it consistent!

A = + so get both As to run to the + on the high level input

B = - so get both Bs to run to the - on the high level input






Print Page | Close Window