wire colors for premier system

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=51273
Printed Date: May 05, 2024 at 4:57 PM

Topic: wire colors for premier system

Posted By: attlfrank
Subject: wire colors for premier system
Date Posted: March 04, 2005 at 10:47 AM

hi
I'm trying to put an amp in a 2000 taurus,,it has a premier system in it already,,I'm wondering if I can use the wires going to the amp that's in it now,,if so what color are the constant and the switched wires,,,I already have the speaker wire colors

Once again Thank You Very Much

Replies:

Posted By: thepencil
Date Posted: March 09, 2005 at 10:50 AM

"what color are the constant and the switched wires"

Get a digital multimeter to test for them, they are not hard to find.

-------------
Be careful whose advice you buy, but be patient with those who supply it. posted_image

Posted By: Chad7n7
Date Posted: March 10, 2005 at 10:06 PM

I really wouldn't think that the wire in that factory harness will provide enough current to supply two amplifiers, the best thing to do in this situation is to run new wires for your aftermarket amplifier.

-------------

Posted By: Ravendarat
Date Posted: March 11, 2005 at 12:06 AM

Ya the constant and switched wires wont be sufficient to run an after market amp. Run new wires and be better safe than sorry.

-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer

Posted By: attlfrank
Date Posted: March 11, 2005 at 10:43 AM

Thanx again for the info guys,,,,,I did notice the wires going to the stock amp were pretty thin,,,,

Again,Thanx

Print Page | Close Window