Hello, I love this web page, it's so helpful, And I was actually hoping that it may help me out again.I'm looking for the Wire Colors that come from a Kenwood KDC-216s wire harness, Such as
Black-ground
Yellow- Power
and so on.
So if anyone would have this information for me, It would be as GREAT help.
Thanks
-------------
Here I Am.
Red - switched +12V
Yellow - Constant +12V
Black - Ground
Blue - Amp remote turn on.
Blue/white stripe - Power antenna
White / WHITE/ Black Stripe - Front Left Speakers
Gray / Gray/Black Stripe - Front Right Speakers
Green / GREEN/ Black Stripe - Rear Right Speakers
Purple / PURPLE / Black Stripe - Rear Left Speakers
That should be all of them, that model didn't have the illumination option, and was before Kenwood introduced tel mute into their line. This is off of memory, and I know the White and Gray are for the front, and Green and purple are for rear. The sequence may be wrong, try hooking one at a time on one designated speaker lead and test.
Before you cut your factory harness in your vehicle to complete this install, I would go to your local stereo shop and buy an aftermarket harness, it will save you time and headache. Also makes the install easier.
-------------
Someone should post the EIA wiring code on a link to the left.... then instead of guys always having to retype it you could just say, click on the link here..... just a thought.....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
the12volt • Support the12volt.com