Eclipse SW9122 Info
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=53024
Printed Date: May 15, 2025 at 4:04 PM
Topic: Eclipse SW9122 Info
Posted By: forbidden
Subject: Eclipse SW9122 Info
Date Posted: April 01, 2005 at 9:00 PM
I have lost my old Titanium driver info and it is going to be at least a week or more before my subs show up. I need the mounting depth, width etc. if someone has it handy.
-------------
Top Secret, I can tell you but then my wife will kill me.
Replies:
Posted By: Chad7n7
Date Posted: April 01, 2005 at 9:20 PM
Here you go Rob. -------------
Posted By: forbidden
Date Posted: April 01, 2005 at 9:37 PM
Close but no banana Chad, unless I missed the info, I did not see the actual physical dimensions of the driver. For the port info, do you know if that was a round port or a slot port? ------------- Top Secret, I can tell you but then my wife will kill me.
Posted By: Chad7n7
Date Posted: April 02, 2005 at 1:21 AM
Rob, the specs are somewhere on here, I had them but lost them, The page I sent wasn't the one I wanted too, but I figured I would send the whole site, as it seems to be a pretty good reference for Eclipse's products. So here you go, hope you can find it!! I kept getting sidetracked and having to start over. -------------
Posted By: Ravendarat
Date Posted: April 02, 2005 at 7:17 AM
size = damn Big wieght = damn heavy hope that helps a little :) ------------- double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Posted By: haemphyst
Date Posted: April 02, 2005 at 9:10 AM
I am looking for the manual for mine. As soon as I lay my hands on the thing, I'll post everything you need... Hang tight, bro'...
(...now where did i see that thing???...)
-------------
It all reminds me of something that Molière once said to Guy de Maupassant at a café in Vienna: "That's nice. You should write it down."
Posted By: DYohn
Date Posted: April 04, 2005 at 5:25 PM
Hey Rob, don't know if you still need this, but I finally got your answer from a friend of mine: The cut out hole for the SW9122 is 11" and the flange depth is 13/16." Mounting depth 8 1/16" box size 0.9-1.25 cuft. for a sealed box. Ported is 3.0 cuft. tuned at 35 Hz ------------- Support the12volt.com
Posted By: haemphyst
Date Posted: April 04, 2005 at 7:18 PM
DYohn beat me to it, again... I had JUST found my manual for that driver, and those are good numbers. Hadn't forgotten about you! Just took longer than I planned on...
-------------
It all reminds me of something that Molière once said to Guy de Maupassant at a café in Vienna: "That's nice. You should write it down."
|