jl 250/1 problem
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54122
Printed Date: May 14, 2025 at 1:46 AM
Topic: jl 250/1 problem
Posted By: nmcclure
Subject: jl 250/1 problem
Date Posted: April 17, 2005 at 11:54 PM
Ok, i've recently installed a 250/1 into my '01 landcruiser. I kept the stock h/u and added a loc tapped into the RED / white and BLACK / YELLOW wires after the factory jbl amp. The amp is set for signal sensing turn on. Now, it plays fine in the car, but the problem comes when i turn the car off. The sub's spl goes through the roof. The keys arent even in the ignition and it has monstor power. The bass seems to build like a stampeed when i turn off the car...its like a tidal wave, but gaining spl instead. What gives?
Replies:
Posted By: sedate
Date Posted: April 18, 2005 at 7:27 AM
That is odd...
How does your stereo turn on without the keys in the ignition? Wouldn't you have to turn them to ACC to play it?
-------------
"I'm finished!" - Daniel Plainview
Posted By: nmcclure
Date Posted: April 18, 2005 at 10:39 AM
sedate, the keys are used in turning it on, but when i turn it off, i can take the keys out prior to the subs spl building....sorry if that was unclear
Posted By: nmcclure
Date Posted: April 18, 2005 at 12:42 PM
fixed, had to run a wire for the remote power instead of using the signal sensing. thanks
|