Eclipse PA5532 ?

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54589
Printed Date: July 14, 2025 at 9:17 AM

Topic: Eclipse PA5532 ?

Posted By: Steven6095
Subject: Eclipse PA5532 ?
Date Posted: April 25, 2005 at 9:14 AM

Hi. I went this weekend to buy an Eclipse PA5532 but something concerned me.

My headunit (Alpine) has front, rear and subwoofer RCAs. (three sets of preouts)

The AMP only has two RCA inputs?

How does this work?

Steven

Replies:

Posted By: Ravendarat
Date Posted: April 25, 2005 at 11:06 AM

Thats because the amp isint 6 channels. What are you going to use the amp to run. BTW this is completly normal, ot a concern at all.

-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer

Posted By: svc
Date Posted: April 25, 2005 at 11:08 AM

Steven

I have this exact amp in my car on an Alpine radio with 3 pre-outs. There is a mono sub input on the amp directly under the output rca. You will need an rca Y-adapter 2 female to 1 male.You will have complete sub control from your deck. Hope this helps.

Tim

Posted By: Steven6095
Date Posted: April 25, 2005 at 11:31 AM

MB Quart Components with the Add A Woofer system
so 2 ohm load on each front channel.

Set of MB Quart COaxials for rear fill

DVC Eclipse sub ( 4 x 4)

Posted By: Steven6095
Date Posted: April 25, 2005 at 11:32 AM

I am looking at a picture of both ends of the AMP and I do not see a mono input...

Posted By: Steven6095
Date Posted: April 25, 2005 at 11:34 AM

I understand whatyou mean by not being a six channel.

Front L + R = 2 channels
Rear L + R = 2 channels
One "sub" = 1 channel

I will stop by today and look at it again to make sure of the inputs.

Print Page | Close Window