Alpine amp model 3006

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54837
Printed Date: June 17, 2024 at 2:42 PM

Topic: Alpine amp model 3006

Posted By: sookesquatch
Subject: Alpine amp model 3006
Date Posted: April 29, 2005 at 3:55 PM

I am looking for a wiring diagram or a schematic for an alpine power amp, model 3006, 18w +18w.

Can anyone help me out? Thanks

Replies:

Posted By: tcss
Date Posted: April 29, 2005 at 4:49 PM

This is really old school, but I think I remember it this way. There should two yellows or a yellow and a white. These are both 12volt constant. Red is 12 volt switched. Black is ground. LF + is GREEN/ YELLOW, LF- is GREEN / WHITE, RF + is grey / YELLOW, RF - is grey/white. It should have an 8 pin DIN input. You only need four pins. On the input 12:00 is signal ground, 1:00 is signal input left, 11:00 is signal input right and 3:00 is remote turn on. Use your volt meter to find which wires in the DIN cord match the pins on the input.

Posted By: racer427
Date Posted: April 29, 2005 at 8:22 PM

Just goes to show you how good Alpine Amps can be if this old school amp is still around kicking.

Chris

-------------
Alpine CDA-9833 HU
Diamond Audio M661 Components
MTX Thunder T6.6 Components:rear fill:
Cadence Q400 4 Channel Mains + rears
Thunder 801D Subs
MTX 1004 10's
Dual 4g wire to rear
4g grounds

Posted By: sookesquatch
Date Posted: April 30, 2005 at 1:07 PM

Thanks , This unit is on a sailboat that I just bought, and it has decided to start blowing a fuse on one of the 12 volt constant lines when the cd deck is turned on. I will check it out when I am out there this weekend.