Wiring 3 type r’s

Basics: 3 Alpine type r (4ohm dual voice coil)
        Viper audio 1200d (made by DEI)
Dilemma:
I am wiring three type r's and i am doing it as pictured. I will post pictures of my custom enclosure tomorrow.



but my amp is a DEI (directed, viper etc) and where you connect the power, ground, remote, speaker + - it is not your average screw connecter but a seperate peice that the wire is inserted into and is than plugged into the amp.

my question is as follows.

when i run all three positive and negative wires... they will not fit in the given hole. Could i run them (12 ga) and use a butt connector to splice all three into a single (8-12 ga) wire and run that to the amp?

essentially i would be running three wires the +, or - and than turning them into one wire before entering the amp.

_____________
_____________ [splice] amp (+)
_____________


_____________
_____________ [splice] amp (-)
_____________

or would that restrict them, thanks for your time

if you follow the directions your showed above you will only have 1 set of wires going to your amp, , i dunno where your getting these 3 wires from.

-------------
2003 Chevy Avalanche,Eclipse CD7000,Morel Elate 5,Adire Extremis,Alpine PDX-4.150, 15" TC-3000, 2 Alpine PDX-1.1000, 470Amp HO Alt.

Run one long wire from each speaker terminal at the amp to the furthest sub.  Tap into those wires for the other two.

-------------
My ex once told me I have a perfect face for radio.

so which way would work best out of those two

Whell i would do it with 9 pieces of wire like the picture describes.

-------------
2003 Chevy Avalanche,Eclipse CD7000,Morel Elate 5,Adire Extremis,Alpine PDX-4.150, 15" TC-3000, 2 Alpine PDX-1.1000, 470Amp HO Alt.