tunning alpine amp for new components

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=56050
Printed Date: May 16, 2025 at 1:04 PM

Topic: tunning alpine amp for new components

Posted By: jussam
Subject: tunning alpine amp for new components
Date Posted: May 19, 2005 at 1:18 PM

i just replaced 2 sets of pioneer 6x8 2 way with 2 sets of 5.25 components and the amp was set low for the 2 ways and need to know do i raise the gain for sound and mhz for clarity

Replies:

Posted By: wirewise
Date Posted: May 19, 2005 at 1:22 PM

the12volt wrote:

Use Plain Text Editors If you edit or format your posts in another editor before pasting them into the message form, please use Notepad or some other plain text editor. Do not use Word! Word and several other rich text editors include code that will cause your posts to be displayed incorrectly. These posts may be deleted without notice.

~wirewise~

Posted By: jussam
Date Posted: May 19, 2005 at 1:33 PM

i did not edit or format my post. i just simply post in the post reply box. sorry it could be my computer it's acting up

Posted By: jussam
Date Posted: May 19, 2005 at 7:16 PM

sorry about the bad post my computer at work was acting up ......... back to my question?

i just replaced my door 2 sets of6x8 pioneer 2way with 2 sets of 5.25 cpmponents but mt alpine amp was tuned low for the 6x8's now i need to adust my amp,so do i raise the gain for sound and my mhz for clarity

Posted By: stevdart
Date Posted: May 19, 2005 at 7:32 PM

You should not adjust the gain. But you can turn the crossover setting a little higher if it makes the new speakers sound better.

-------------
Build the box so that it performs well in the worst case scenario and, in return, it will reward you at all times.

Posted By: jussam
Date Posted: May 19, 2005 at 8:17 PM

thanks stevdart with your quick response

Print Page | Close Window