Print Page | Close Window

what amp to push four 15'' kicker compvr's

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=56151
Printed Date: April 19, 2024 at 8:47 PM


Topic: what amp to push four 15'' kicker compvr's

Posted By: chris305
Subject: what amp to push four 15'' kicker compvr's
Date Posted: May 21, 2005 at 7:44 AM

what ampilifer should i get to push 4 15's kicker compvr's there 500rms/1000max  (each).  what ampilifer will push out 2000rms power? any suggestions? and my price range im looking at is between 200.00-800.00$




Replies:

Posted By: racer427
Date Posted: May 21, 2005 at 11:36 AM

First off, are you gonna run them in a sealed or vented enclosure?

Second: Do you have the Big 3 done?

Third, A true 2000w amp is gonna cost way more than your stated budget. Don't be fooled by amps that state they put out that much power but only cost between $200-$800.

Here is an example of a true 2000w amp and look at the price.

https://www.cardomain.com/item/JBLBPX22001

Chris



-------------
Alpine CDA-9833 HU
Diamond Audio M661 Components
MTX Thunder T6.6 Components:rear fill:
Cadence Q400 4 Channel Mains + rears
Thunder 801D Subs
MTX 1004 10's
Dual 4g wire to rear
4g grounds




Posted By: pimpincavy
Date Posted: May 21, 2005 at 2:29 PM
You can get a HiFonics Brutus 2200W amp that will fit in your price range.

-------------




Posted By: audiobass10
Date Posted: May 21, 2005 at 3:03 PM
I'm currently running a 15" CVR off a profile AP1000M rated for 500w rms x 1@ 2 ohms. It only cost me $120 shipped and I haven't had a problem with it yet. It gives the sub plenty of power so i'm confident it does rated power or atleast very close to it. You could run 4 of those for $480 shipped and get a damn loud setup. I'm really startin to like profile's amps for budget installs. Hence the reason I used one myself. Just make sure your electrical system is up to par and you'll be fine.

-------------
Dave

Pioneer Premier DEH-P660
15" Kicker CVR
Profile AP1000M
It's Loud




Posted By: skoldspuppy
Date Posted: May 21, 2005 at 4:49 PM

You can get 2000 watts amps for your price range as long as you dont buy authorized search for these on ebay

You can get brand new HIFONICS XX-HERCULES amps which are 2000 watts @ 1ohm for under $500
Or you can get the HIFONICS XX-Colossus amps which are 3200 watts @ 2ohms for around $700

You can also look at The Crossfire VR2000D ive seen it on ebay brand new for around $700
Also another one would be the US Amps USA-2000 it does 2000 watts @ 2ohm for about $800

there are plenty more I just dont have the time to list them all

Later

---Skold



-------------
2004 Honda Civic Ex 4Dr

Kenwood DDX-7015/W Nav
4 Fosgate T152C
Hifonics Brutus BX1500D
RE XXX 12 in a 4 Cube Snail Shell




Posted By: Teamrf
Date Posted: May 21, 2005 at 4:51 PM
I have two of those 15's on a single Kicker 1200.1 and it sounds good.

-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.




Posted By: supradude
Date Posted: May 21, 2005 at 10:29 PM
pimpincavy wrote:

You can get a HiFonics Brutus 2200W amp that will fit in your price range.
Let me know if you want one. I have one that I can't get enough power to, so I can't play it like it's capable of. 

-------------
'85 Toy




Posted By: drvnbysound
Date Posted: May 22, 2005 at 3:17 AM
As already stated, you will need a good quality amp that is actually capable of pushing 2000W RMS. A Pyramid 2000W amp isnt going to do the trick. If you are planning to use CompVR subs, I would suggest you stay within the same company and go with a Kicker KX2500.1 This amp is capable of 2500W RMS @ 2ohm load.

For any amplifier to actually output 2000W RMS you will need a charging system capable of running 145 amps, not including the other amps used for your mids and highs. This usually suggests that you run a multiple battery setup with a high output alternator. Personally I would suggest 2-3 SVR Batteries and a 180-200 amp alternator.

Spending high dollar on a quality amp alone doesnt do any good if you dont have the charging system to give the amp the current it needs to produce high output wattages you desire. If you are planning to go with a big system make sure you upgrade the electrical system (batteries / alternator) or you might as well stick with a 500-1000W RMS setup because thats about all you will get out of a stock charging system.

-------------




Posted By: audiobass10
Date Posted: May 22, 2005 at 3:17 PM

drvnbysound wrote:

As already stated, you will need a good quality amp that is actually capable of pushing 2000W RMS. A Pyramid 2000W amp isnt going to do the trick. If you are planning to use CompVR subs, I would suggest you stay within the same company and go with a Kicker KX2500.1 This amp is capable of 2500W RMS @ 2ohm load.

For any amplifier to actually output 2000W RMS you will need a charging system capable of running 145 amps, not including the other amps used for your mids and highs. This usually suggests that you run a multiple battery setup with a high output alternator. Personally I would suggest 2-3 SVR Batteries and a 180-200 amp alternator.

Spending high dollar on a quality amp alone doesnt do any good if you dont have the charging system to give the amp the current it needs to produce high output wattages you desire. If you are planning to go with a big system make sure you upgrade the electrical system (batteries / alternator) or you might as well stick with a 500-1000W RMS setup because thats about all you will get out of a stock charging system.

Staying with the same company has no other benefits other than preference. Since it appears he's looking for a low budget SPL install, bias should be thrown out twoards companies that are considered lower end products (i.e. Power Acoustik, Profile, Lanzar etc.)



-------------
Dave

Pioneer Premier DEH-P660
15" Kicker CVR
Profile AP1000M
It's Loud




Posted By: spyder340
Date Posted: May 22, 2005 at 11:38 PM
i currently use a power acoustik amp to push 2 comp vr 15's, i've been running power acoustik and spl brand for about 2 years now and have no problems what so ever.

-------------
96 firechicken- kicker cvr 15's, spl 1600 watt, optima yellow top, 2.0 farad cap, sealed box and 146.8 db :)<---now upto 147.2 S2 meca class, going for 128 on a drive by :)




Posted By: chris305
Date Posted: May 27, 2005 at 3:28 AM

well i hear sealed boxes are good and ported is too. i listen to mostly rap n r & b  music so whatevers best with that type of music i guess. i want a ported more tho. but when i had my last ported i tend to blow my subs . and the sealed i had man i had it for months never blown them. so i dont know  any advices






Print Page | Close Window