91 Explorer Sub Install
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=56166
Printed Date: May 14, 2025 at 8:00 PM
Topic: 91 Explorer Sub Install
Posted By: compwc18
Subject: 91 Explorer Sub Install
Date Posted: May 21, 2005 at 3:10 PM
Im installing a system into my 91 Explorer, and Ic ant find a place where I can run my power wire through, I need to know the best place to run my wiring.... I also need to know the best place to run the wiring through, I was thinking down the side... lmk I really need help ASAP. Thank you.
compwc18
Replies:
Posted By: wayland1985
Date Posted: May 21, 2005 at 9:09 PM
My 1994 Explorer:
Across top of radiator, along driver fender.
If you have an automatic, then there is a plate covering the area where the clutch pedal would have been. Drill through that plate (it's probably the easiest and safeste place to drill).
Run the wire along the driver's side. If the wire is small enough, you can hide it underneath the plastic door sills.
-------------
~WAYLAND
Posted By: compwc18
Date Posted: May 21, 2005 at 9:42 PM
I just installed a stereo into a 91 Explorer. I ran all of the wires to the correct sports, power ground and remote, but my amp is not powering on.... The fuse in the amp is good and so is the fuse that goes on the power wire.... What could be my issue here.... Somebody please help, I really need to get this done. Thank you.
Posted By: ss-installer
Date Posted: May 22, 2005 at 12:20 AM
factory or aftermarket HU? are you getting any voltage from the blue remote wire?if not, try the red key switch.
-------------
Posted By: compwc18
Date Posted: May 31, 2005 at 3:50 PM
where is the red key switch...???
Posted By: hawn13
Date Posted: May 31, 2005 at 7:08 PM
column ignition harness
|