2005 Nissan Altima 2.5S Sound System
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=57614
Printed Date: April 28, 2024 at 6:52 PM
Topic: 2005 Nissan Altima 2.5S Sound System
Posted By: krayzie2k3
Subject: 2005 Nissan Altima 2.5S Sound System
Date Posted: June 13, 2005 at 2:12 PM
objective: install a 12" sub question: what is the best way to get the signal from the head unit? on other cars [2000 and older] i just got a RCA converter that takes the rear input and converts it into a RCA plug, run that to the amp and done. can this be done the same way?
Replies:
Posted By: us_test
Date Posted: June 13, 2005 at 3:45 PM
Yes use a good brand converter (cheaper brands have noise on the line most of the time - no pyle, pyramid, etc). I'm not too familiar with the hu in the altima 2.5S but I don't think it has RCA outputs. Line driver to boost the signal would also bee a very good option.
Posted By: krayzie2k3
Date Posted: June 20, 2005 at 5:11 PM
this may sound like a noob, but which wire would i connect to the factory harness for the amp turnon lead? i usually connect it to the power ant wire but with that way, the amp only comes on when the radio [am/fm] is on. when i turn on the CD mode, it turns the amp off. on the altima, there is another wire for a amp out [im assuming] lead. but before i hook it up, i was thinking, if i connect it to that, would that mean the amp would only come on in cd mode? or should i run 2 wires for the amp turnon lead input on the amp? thanks
Posted By: LTHLQUICKSILVER
Date Posted: June 20, 2005 at 5:28 PM
You can connect the amp turn on lean to any accessory (ignition/turn on) wire you find behind the dash, even the one the stereo is using. You don't need a dedicated amp turn on, just one that turns on with the car.
------------- Muscle Cars Don't Just Look Good, But They Can Sound Good Too...
1971 Chevelle SS
Posted By: krayzie2k3
Date Posted: June 20, 2005 at 11:02 PM
i was thinking to conenct it to the 12v ign so it would come on when the car is turned on. the reason i hesitate is i dont know what voltage the remote wire needs so i didnt want to plug into 12v and fry it
Posted By: mthomecouple
Date Posted: June 21, 2005 at 12:55 PM
you can use just about any wire that is controlled by the ignition
------------- joe
|