A/D/S Din Plug - Pin Configuration

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=57726
Printed Date: May 05, 2025 at 10:04 AM

Topic: A/D/S Din Plug - Pin Configuration

Posted By: OBWAN
Subject: A/D/S Din Plug - Pin Configuration
Date Posted: June 15, 2005 at 2:27 AM

Hi All,

First post...great site and forum!

I have an old PH15 that I dug out of the closet, but I no longer have the DIN cord that I used in the original install. I'd like to make up a RCA - DIN cord so that the amp can be used with non-A/D/S crossovers etc., but I don't know what the pin configuration is. Would anyone out there happen to have this information?

I checked the A/D/S website, but they don't have any manuals for their older stuff. Thanks in advance for any help that you might be able to provide!

Brian

Replies:

Posted By: dwarren
Date Posted: June 15, 2005 at 12:51 PM

I believe any 8-pin din cable will work. I have had to make a few for my self. You will need a meter to check continuity.

I do recall that the shield is not hot.

-------------

Posted By: Ween
Date Posted: June 15, 2005 at 9:17 PM

hi,

looking at A/D/S AC201 adaptor cable (pinout shown on packaging). imagine it as a "U" with a "." in the middle. starting on the left and going CCW the pinout is....chnl 5, chnl 2, chnl 1, signal gnd, chnl 3, chnl 4, chnl 6. the center pin is turn-on/trgger. hopr this helps.

mark

Posted By: OBWAN
Date Posted: June 15, 2005 at 11:53 PM

Thanks for your help everyone!

Brian