Print Page | Close Window

2000 Corolla VE CD Deck

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=57915
Printed Date: April 23, 2024 at 1:58 AM


Topic: 2000 Corolla VE CD Deck

Posted By: dannyboi
Subject: 2000 Corolla VE CD Deck
Date Posted: June 17, 2005 at 4:50 PM

I'm installing just a plain cd deck to my friends Corolla. He told me before of something happening that I am not sure of, but it blew out the center light, the clock, and the lighter.  I figured it would be the fuses so I replaced the dome and lighter fuse and it now works.  The clock stil doesn't work.  So I hooked up the battery, ground, and ignition from the car to the deck.  Turned the ignition and the cd deck doesn't turn on.  I tried checking every fuse, but it all seems fine.  Is it not turning on because of the fuse from the clock????... or something else in mind... I couldn't figure out any other possibility so if anybody can help please suggest any other troubleshooting methods... thanks

-------------
"the greatest skill of a person is a skill unknown"



Replies:

Posted By: Chad7n7
Date Posted: June 17, 2005 at 10:01 PM
Did you use an aftermarket harness for this install?? Or did you hack the factory harness in the vehicle??

-------------




Posted By: dannyboi
Date Posted: June 18, 2005 at 2:50 AM
I hacked the factory harness because someone before cut it off

-------------
"the greatest skill of a person is a skill unknown"




Posted By: Chad7n7
Date Posted: June 18, 2005 at 9:33 AM

Check all of your connections, in this vehicle, This is the reason aftermarket harnesses make the install alot easier. Also check under the hood, I don't know about this vehicle right off, but most Toyota's in general, have a fuse box under the hood. Check in there for a radio fuse. There is usually one inside the car and one under the hood on Toyota.

Here is the wiring diagram to help ensure you have made the correct connections.



-------------




Posted By: dannyboi
Date Posted: June 19, 2005 at 2:55 AM

Chad,

     THANKS ALOT!!! that wiring diragram helpd alot, the colors for the wires are mixed up.  Alright I am goin to test it tomorrow and it should be working.  Thanks again



-------------
"the greatest skill of a person is a skill unknown"





Print Page | Close Window