Hey Everyone,
I'm in the process of trying to match up my subs with an amplifier(s). I have a tentative match and I just would like to know your opinion.
Subs: Pioneer Premier TS - W1500SPL (here are the specs)
And I was thinking about running the coils in parallel (producing 2 Ohms/sub) and then matching each sub with this amp.
JBL GTO601.1
SPECIFICATIONS |
Power Output: | 424 watts RMS x 1 channel at 4 ohms and ¡Â 1% THD + N
580 watts RMS x 1 channel at 2 ohms, 14.4V supply and ¡Â 1% THD + N |
Signal-to-Noise Ratio: | 72dBA (reference 1 watt into 4 ohms) |
Dynamic Power: | 580 Watt at 4 ohms |
Effective Damping Factor: | 6.326 at 4 ohms |
Frequency Response: | 10Hz - 302Hz |
Maximum Input Signal: | 5.3V |
Maximum Sensitivity: | 210mV |
Output Regulation: | .21dB at 4 ohms |
Thanks a lot for you help
Jason
Any other recommendations would be greatly appreciated
dat sounds decent, da amp seems gud. u cud also look into an alpine mrd-m605. very nice amp runs at 600w rms at 2ohm. also its digital (no nobs)so it will have the advantage of less noise down ur channel not dat it matters. ur choice but i wud go for da alpine
-------------
6* Rockford T2's
6* POWER AMPs
BLACK CORRADO
BAANNGGIINN