2 re sx dual 2 ohm sub wiring

I ordered my re sx's and they will be here soon
they are dual 2 ohm subs and I have 2. Are my only options to run them in 1/2 ohm or 8 ohm. I have the brutus 2005d mono amp. How can I get the amp to see 1 ohm or at least a 2 ohm load? I have 2 speaker terms on the amp if that helps.

Net load: 2 ohms

Paul

RE has wiring diagrams on their website - https://www.reaudio.com/html/wiring.htm

-------------

ok they do have the wiring info on the website but I was asking for a different way to wire them then what was on the website.

Two DVC 2 ohm subs are wired just as Paul showed you in the diagram above, for a load of 2 ohms on the amp.  Rule:  if you don't find the wiring in a wiring diagram for the subs you have to work with, don't make up  your own way of wiring.  If it were possible, it would be shown.  Here are a couple of wiring wizards that make life easier:

Subwoofer wiring guide

Woofer wiring wizard

In cases where multiple subs are too many to be shown in a wiring guide, you can use series and parallel calculators such as the ones on this site:  https://www.the12volt.com/caraudio/boxcalcs.asp#par

Always calculate the voice coils first, then the subs.  For example, if you hear "series/parallel", that's referring to DVC subs with coils in series and subs in parallel.  The diagram above is an example.

-------------
Build the box so that it performs well in the worst case scenario and, in return, it will reward you at all times.