2000 toyota sienna color codes for audio

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=58799
Printed Date: May 05, 2024 at 5:20 PM

Topic: 2000 toyota sienna color codes for audio

Posted By: imspidey
Subject: 2000 toyota sienna color codes for audio
Date Posted: July 04, 2005 at 12:38 AM

i dont have the standard setup for this vehicle so the aftermarket adapter plugs dont fit...i have an upgraded system through toyota that essentially has a built in amp and the plugs are different. this website as well as others show wire colors that are only accurate for the rear speakers.

-------------
imspidey

Replies:

Posted By: Velocity Motors
Date Posted: July 05, 2005 at 9:25 AM

Wire Function	Color	Note	Fuse #	Size	Location

+12V DC Battery(Constant)	Blue / YELLOW		Radio 1	20 Amp	Junction block on left side of engine compartment.

Switched Accessory	Gray		Radio 2	7.5 Amp	Junction block behind dash, on left side of steering column.

Ground	Brown

Power Antenna	BLACK/ red

Remote Turn On(output)	Violet

Illumination	Green & WHITE/ green

Mute	Blue

Left Front +	White	Line level output

Right Front +	Red	Line level output

Left Rear +	Yellow	Line level output

Right Rear +	Brown	Line level output

AMPLIFIER OUTPUTS

Wire Function	Color	Note	Fuse #	Size	Location

12V DC Battery	Blue / YELLOW		Radio 1	20 Amp	Junction block on left side of engine compartment

Remote Turn On (input)	Violet	Also gray for accessory switch, thru radio 2 fuse as above.

Left Front Mid +	Pink

Left Front Mid -	Violet

Left Front Tweeter +	Blue / YELLOW

Left Front Tweeter -	Blue/black

Right Front Mid +	Light green

Right Front Mid -	Blue

Right Front Tweeter +	Blue/white

Right Front Tweeter -	Blue/red

Left Rear Mid +	Black

Left Rear Mid -	Yellow

Right Rear Mid +	Red

Right Rear Mid -	White

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: imspidey
Date Posted: July 08, 2005 at 11:14 PM

thanks for the additional info however the colors still dont match.....am i going to be able to wire from the current plug wires or am i going to have to go to the harness? also is there a way to test where the wires go to figure them out that way? thanks

imspidey

-------------
imspidey

Posted By: Velocity Motors
Date Posted: July 09, 2005 at 12:31 AM

Most of the time the radio plug fits in after the amplifier. Have you checked to see if the plug fits the output on the amplifer ?

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA