Print Page | Close Window

Pushed DIN receiver in too far, how to?

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=59457
Printed Date: April 29, 2024 at 2:16 AM


Topic: Pushed DIN receiver in too far, how to?

Posted By: MKtree
Subject: Pushed DIN receiver in too far, how to?
Date Posted: July 14, 2005 at 10:18 PM

Dumb Deal:  Installing a friends DIN size CD player in a hurry, had the DIN frame securely set in vehicle opening, go to push in the receiver and instead of it clicking it went in an extra 1/4".  Granted, it's secure and works fine, but the trim doesn't fit, and its obviously not right.  I want to know how to pull it back without pulling it apart.  It's a flip down face, and I flipped it down and gave it a pull, but no go, I couldn't pull too hard, because I don't want to pull it apart, I've gone to my limit on safely pulling.  ANY ideas, suggestions, expierences, at all please let me know.  Thanks!




Replies:

Posted By: kd7nfr
Date Posted: July 14, 2005 at 11:32 PM
It should have come with some little metal peices that will fit down in two slots on the sides and will click into place so you can pull it out. Hope this helps!



Posted By: MKtree
Date Posted: July 15, 2005 at 12:46 PM
thanks, that's right, I'll give it a try!  Thanks a ton



Posted By: MKtree
Date Posted: July 16, 2005 at 10:01 AM
got,it, thanks


Print Page | Close Window