Factory Sub
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=60037
Printed Date: May 12, 2024 at 11:47 PM
Topic: Factory Sub
Posted By: cnschweg
Subject: Factory Sub
Date Posted: July 25, 2005 at 11:36 AM
I was told I could use the factory inputs to the factory sub amp on an aftermarket amp, as long as I put rca ends on them. I'd run a new power lead, but would like to use the factory signal wires if possible. does anyone know which wires these are? Thanks
-------------
Craig---
Replies:
Posted By: JAydawg21
Date Posted: July 25, 2005 at 12:14 PM
well, if your using the wires that acctually connect to the sub itself, you either need to buy an amp that has a high voltage input, or buy a live converter to step down the signal. The signal that appears across the acctuall speaker terminals has already been amplified and is too large for standard rca inputs which are typically around 4 - 5 volts
-------------
'97 Jeep Cherokee sport
subs: JL 12w3v2 : RF 500a2 :
RF 1F capacitor
doors: 6" Diamond D361i -> RF 200a4
|