Can anybody help me with the color codes for this truck? I have an open slot with two connectors but have no idea what color does what? Any help would be greatly appreciated. I need to get this stereo in!!!!
Try this-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Thank you very much. I have been trying to find this information thru google all last night with no luck. Thank you again for the help!!!
Well all you had to do was look up to where it says diagrams.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Well i must have missed that diagrams like last night i guess...? I printed out that wiring diagram that you sent a link to and checked it with what i have and they dont match up? If this helps i have:
One block connector with:
BLACK/ purple
pink/blue
GREEN/ orange
WHITE/ green
BROWN / yellow
pink/green
blue/white
ORANGE / green
and the other block connector has these:
BLACK/ green X2
ORANGE / black
blue/red
yellow/black
black
GREEN/ black
If anyone could help i would greatly appreciate and thanks in advance.
Try this-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Ok those colors didnt match either. i did check the power ground and accessories wire though and although the colors didnt match they were correct as to that diagram. Would it be safe to say that the other connector which i am thinking would be the speaker wires, should match that PDF document reguardless of color?
OK Auex i am a retard. I went to best buy and bought the connector. I installed the radio and everything is good. When i was done i finally realized that it did not matter that my colors didnt match those on the diagram that you sent but what the pins in the connector were used for. Sorry for the hard time. Thanks for the help.