sub wiring ohm

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=63141
Printed Date: November 04, 2025 at 1:50 AM

Topic: sub wiring ohm

Posted By: june
Subject: sub wiring ohm
Date Posted: September 23, 2005 at 10:30 AM

ok is there any possible way that i can wire 2 dual voice coil 4 ohm speaker to see 4ohm i have one way but im not sure if that the right way i wired each speaker to see 2 ohm which is parallel then i will take both and put it in series is that safe for the mono amp which is 4 ohm right??????????????

Replies:

Posted By: jstruckman
Date Posted: September 23, 2005 at 10:35 AM

You will usually want to wire the voice coils in series so each sub is 8 ohms. then parallel the subs to bring it to a 4 ohm load.

Jazzy

-------------

Posted By: haemphyst
Date Posted: September 23, 2005 at 10:40 AM

june] wrote:

ok is there any possible way that i can wire 2 dual voice coil 4 ohm speaker to see 4ohm i have one way but im not sure if that the right way i wired each speaker to see 2 ohm which is parallel then i will take both and put it in series is that safe for the mono amp which is 4 ohm right??????????????

You are correct as well... Leave it that way.

-------------
It all reminds me of something that Molière once said to Guy de Maupassant at a café in Vienna: "That's nice. You should write it down."