Getting the right impedence

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=64020
Printed Date: July 07, 2025 at 11:28 AM

Topic: Getting the right impedence

Posted By: arrow12
Subject: Getting the right impedence
Date Posted: October 07, 2005 at 9:22 PM

I am going to have have 6 speakers each with a 2 ohm impedence. the amp i will be using will be 6-channels and 2 ohm stable. is there any way to get the speakers to be wired into a 4 ohm or 2 ohm load?

-------------
That's my opinion. Take it, leave it, or correct me.

Replies:

Posted By: DYohn
Date Posted: October 07, 2005 at 9:38 PM

If your speakers are 2-ohms each, then one to a channel will create a 2-ohm load on the amp. Is that what you're asking?

-------------
Support the12volt.com

Posted By: arrow12
Date Posted: October 07, 2005 at 9:43 PM

i think i just asked a really stupid question. but i just need to clarify. each speaker will count as its own channel which means that each channel will have a 2 ohm load. right? so then if each channel is at 2 ohms the amplifier can still handle it. i think i understand my stupid question. thanks for your comment. it made me realize how simple the answer was.

-------------
That's my opinion. Take it, leave it, or correct me.

Print Page | Close Window