Alpine mono amp

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=64213
Printed Date: August 25, 2025 at 4:51 AM

Topic: Alpine mono amp

Posted By: jbravoj
Subject: Alpine mono amp
Date Posted: October 11, 2005 at 9:29 PM

i have an Alpine MRD-M1005 mono amp.

RMS Power (at 12V,20Hz-200Hz)

Per channel into 2 ohms : 700W x 1
Per channel into 4 ohms : 500W x 1

I want to run at 2 ohms - 2 12" subs to this amp. What subs would be the perfect mach for this amp.

Replies:

Posted By: dwarren
Date Posted: October 11, 2005 at 9:32 PM

Use the woofer wiring diagram....https://www.the12volt.com/caraudio/woofer_configurations.asp

Two 2-ohm dvc woofers

or Two 4-ohm svc woofers.

-------------

Posted By: jbravoj
Date Posted: October 11, 2005 at 9:33 PM

I only have a top mount depth of 6.5 inches

Posted By: jbravoj
Date Posted: October 11, 2005 at 9:34 PM

wow.. that was a quick reply posted_image

Posted By: dwarren
Date Posted: October 11, 2005 at 9:35 PM

You wanted specific woofers?

-------------

Posted By: jbravoj
Date Posted: October 11, 2005 at 9:40 PM

just the specs.. like what kinda of rms woofers should i get

Posted By: jbravoj
Date Posted: October 11, 2005 at 9:42 PM

if this amp pushes 700X1, connecting the subs in parallel, would the both subs get 700 watts or would it be divided by 2. 350 for each sub.

Posted By: Blowntweeters
Date Posted: October 11, 2005 at 10:14 PM

each sub will get 350 rms

your very limited wit your mounting depth. you could run 1 12" soundstream van gogh www.soundstream.com

-------------
1974 ford pinto 4 15" punch Z power punch bd 1001 pioneer DEH-6700

Print Page | Close Window