Print Page | Close Window

Amp rack plexi glass window how to

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65514
Printed Date: July 07, 2025 at 4:45 PM


Topic: Amp rack plexi glass window how to

Posted By: _Keith_
Subject: Amp rack plexi glass window how to
Date Posted: November 02, 2005 at 10:48 PM

Ok I been doing fiberglass and all but my main question is when you guys do a amp rack and do the plexi window how are you holding it in? Are you just covering the wood in whatever then squeezing it in or are you bolting it down? I want it to look clean and not be able to see whats holding it in.

Thanks



-------------



Replies:

Posted By: RalphWiggum
Date Posted: November 03, 2005 at 12:12 AM
I have used items similar to these...usually the metal mending plates stretched across the corner of the plexi so it cannot be seen.

posted_image



Posted By: jstruckman
Date Posted: November 03, 2005 at 9:31 AM
Most plexi install are screwed down and then have a cover panel over them, usually wrapped in vinyl to make it look clean.

Jazzy

-------------


Print Page | Close Window