mitsubishi infiniti system
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65707
Printed Date: May 01, 2024 at 10:00 PM
Topic: mitsubishi infiniti system
Posted By: danman1
Subject: mitsubishi infiniti system
Date Posted: November 06, 2005 at 1:07 PM
I recently purchased a 2000 mitsubihi eclipse and the radio comes on but no sound so i deceded to replace the radio ....So i replaced it and have the same problem with the new one was wondering if anyone woild have any tips for success with this problem...thankyou
Replies:
Posted By: dwarren
Date Posted: November 06, 2005 at 1:18 PM
Well, I would look at the fuses, so long as you are one hundred percent sure about your wiring. There may two fuses to look at as well, one under the dash and one under the hood. Did you use a wiring harness? Actually, upon checking crutchfield, there is a factory amp in your vehicle which needs to be bypassed. In order to do this, you will need to rewire all the speakers to the new deck. -------------
Posted By: menace2sobriety
Date Posted: November 06, 2005 at 1:21 PM
are there speakers in the car? are they hooked in? or they could be grounding out.
-------------
Posted By: bestbuymn
Date Posted: November 06, 2005 at 11:44 PM
If you used a wire harness... is the blue/white wire on the deck hooked up to either the blue or the blue/white wire on the vehicle harness?? I had an older eclipse than yours( i believe it was like a 97/98 or something close) in at our shop with an infinity system.... fired the amp turn-on lead up and it fired up the infinity system.
Posted By: Tegpilot
Date Posted: November 07, 2005 at 12:08 AM
The mits's I worked, with the infinity factory amp had a Din 5 pin to Rca adapter to power the amp, did you see any thing on the back of the factory radio that had a 5 pin Din cable connection???
-------------
99 INTEGRA LS 4DR Forest Green.Alpine CDA9857 Deck. JBL 755.6 AMP, Kappa 50.7cs Front, Kappa 6x9's Rear, 4 JBL GTO804 subs
Posted By: bestbuymn
Date Posted: November 07, 2005 at 9:12 AM
Tegpilot- the mitsu that i had with the infinity had the regular mitsu plugs as well as a few other cables... i cant remember if the was a din cable or not.. but i just threw a mitsu harness on and wired it up with the amp turn-on and it workerd.... despite the others in the shop telling me that it wouldnt.
Posted By: Fastlearner
Date Posted: November 07, 2005 at 12:48 PM
You do have to bypass the amp under the pass seat. It's only one plug at the amp with the inputs and out puts. You can do one of two things. You can take speaker wire and run it the amp from the headunit or you can unplug the amp and re-run the harness up to the spot were the head unit is. It makes it a little easier. You will have to clip some zip ties and work with it but the amp harness will reach up there. Also your going to have to unplug your center channel speaker. If you never done this car before i would suggest taking it to a shop and have a pro do it. However it isn't that bad.
|