factory hole in firewall in 04 neon srt-4

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65772
Printed Date: May 16, 2025 at 11:05 PM

Topic: factory hole in firewall in 04 neon srt-4

Posted By: nesaudio
Subject: factory hole in firewall in 04 neon srt-4
Date Posted: November 07, 2005 at 1:37 PM

Hi, i wanted to know if any of you guys found a factory hole in the firewall of a neon srt 4. I looked and i couldnt find one, i would hate to drill a hole in to the firewall ive heard lots of bad storys about drilling threw holes and hitting plates and wires. Thaks guys

-------------
((NEsAuDiO))

Replies:

Posted By: youngone
Date Posted: November 07, 2005 at 8:25 PM

look for boots and fitings that you can run it trough. if it is an automatic there could be a plate where the cluch would be if it has bults on it take it of and drill a hole and but it back on. if there isent enything to run it trough then you are going to have to drill a hole. take a scrudrive or a punch and make a tiny dent in the fire wall and fell for it on the other side and see or feel if there is enything in your way if there is then try someplace else that would work and try the same thing. if that dosent work or you dont want to dril a hole then wight till somebody has a solution. this forum has alought of people that do tis for a job so gust be pasent and you will get what you are looking for.

Aaron posted_image

-------------
Want to know some good equipment- JL,Adire Audio,Mcintosh,Brax,Helix,Eclipse,JBL,RE,Dimoand Audio,Zapco, pritty much anything DYhon,Forbidden recommend
On the12volt you give some info and you get in

Posted By: menace2sobriety
Date Posted: November 08, 2005 at 1:30 AM

yes check once twice and once more. before you drill any holes. and always use a grommet. to protect the wire from being cut.

-------------

Posted By: sedate
Date Posted: November 08, 2005 at 10:46 PM

yea I always drill a *reallllly* tiny hole with a supa-small bit.. then thread a paper-clip through and make sure it comes out a good spot.

-------------
"I'm finished!" - Daniel Plainview