where to run power thru firewall

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65785
Printed Date: May 15, 2025 at 9:41 PM

Topic: where to run power thru firewall

Posted By: colaroaster
Subject: where to run power thru firewall
Date Posted: November 07, 2005 at 3:40 PM

i've looked and i can't seem too find a factory grommet/hole too run my 4ga power wire thru. can anyone tell me where too find a place in the firewall or will i just need too drill my own hole? it's a 93 jeep cherokee. thanks

Replies:

Posted By: ss-installer
Date Posted: November 07, 2005 at 5:33 PM

if it is an automatic tranny then there should be a clutch plate right to the left of the brake mount. it should be held in with 2 bolts. take it out and drill the hole and put it back in.

-------------

Posted By: youngone
Date Posted: November 07, 2005 at 8:15 PM

sounds like a plan posted_image

-------------
Want to know some good equipment- JL,Adire Audio,Mcintosh,Brax,Helix,Eclipse,JBL,RE,Dimoand Audio,Zapco, pritty much anything DYhon,Forbidden recommend
On the12volt you give some info and you get in

Posted By: blackcr125
Date Posted: November 07, 2005 at 9:46 PM

No need to drill or unbolt anything. I had a 93' Cherokee. Say your facing the front of the car, there will be a hole for the main harness on the far right side of the firewall. If you can't find it that way, then go in your drivers side, take off the grey panel that covers the fuse panel and hood release assembly, look up and to the left on the firewall and you should see it.

Posted By: colaroaster
Date Posted: November 08, 2005 at 11:33 PM

thanks for all the help, you guys rock!

Print Page | Close Window