Print Page | Close Window

aftermarket amp to factory radio

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=67020
Printed Date: May 17, 2025 at 1:46 AM


Topic: aftermarket amp to factory radio

Posted By: ezko84
Subject: aftermarket amp to factory radio
Date Posted: November 25, 2005 at 8:47 PM

after all day of searching online I still can not figure out the wiring schematics of my stereo system.

I am installing an after market amplifier from my factory radio to power a sub.  the only problem is that there are no RCA output jacks on the radio.  So I purchased a HI-LO line converter that has 1 pair stereo outs, 2 grey, and 2 white wires that need to be spliced and installed from the factory radio.  I would like to know where these 4 wires get connected to.

I also need to wire the rem from the amp.  I am not exactly sure where it gets wired to. 

I have a 06 Toyota tundra

Toyota factory cd tape deck (fujitsu-ten)




Replies:

Posted By: godblessdremil
Date Posted: November 25, 2005 at 10:30 PM
For remote wire(if you are getting it from the fuse box) i would use an unimportant slot that gets only accessory power, because sometimes things burn out.


Print Page | Close Window