12 W3 truck box finished, pictures
Printed From: the12volt.comForum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=69507
Printed Date: May 15, 2025 at 2:45 PM
Topic: 12 W3 truck box finished, pictures
Posted By: customsuburb
Subject: 12 W3 truck box finished, pictures
Date Posted: December 29, 2005 at 5:42 PM
Ok I finally finished a ported truck box for my friends 12 W3. It was basically built to JL's specs for a ported box. My dad and I had to cut almost everything with a circular saw or jigsaw so some of the cuts were a little off... I still think it turned out great though. Once carpet was put on it covered up the few flaws in it.
It sounds pretty good in the truck. The lows arn't too bad and it can get decently loud. It barely fits though, and the sub is almost touching the back of the drivers seat (I had to flush mount the sub to take off a little extra depth). It's being power by the bridged rear channels of a kenwood 4 channel amp so it's only getting about 150 watts RMS or so. It still vibrates the drivers seat enough to where you can see the cushion moving though. :D
Here are some pictures I took. Sorry I didn't get any of it in the truck.
Replies:
Posted By: dwarren
Date Posted: December 29, 2005 at 5:49 PM
Posted By: geepherder
Date Posted: December 29, 2005 at 6:59 PM
Posted By: tex12gage
Date Posted: December 30, 2005 at 4:53 PM