Massive Sub Wiring

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=71908
Printed Date: July 12, 2025 at 10:37 AM

Topic: Massive Sub Wiring

Posted By: Walkercustoms
Subject: Massive Sub Wiring
Date Posted: January 31, 2006 at 12:22 PM

I have a guy that wants 6 Kicker Free Airs installed and be pushed by an old punch45. Yes, I know what is he thinking but, you know how it is his buddy said he had it hooked up that way and so on. Now, he has check this out 4 4ohm and 2 8ohm subs. Is there anyway I could hook these up to the old punch so, I can get him out of my hair?

Thanks

Replies:

Posted By: Walkercustoms
Date Posted: January 31, 2006 at 2:34 PM

It is a Punch 200 DSM 2-Ch not a punch45. The specs are as follows 100x2@4ohm, 200x2@2ohm and 400 per mono block at 4ohm. Any help with hooking up would be great with the sub setup I posted before. It will have to be seris and parr I assume.

Thanks

Posted By: DYohn
Date Posted: January 31, 2006 at 3:20 PM

It's a strange configuration and it'll have loudness imbalances, but I'd wire it as two sets of 8-ohm loads in parallel. Use the 4-ohm woofers in series-parallel and the 8-ohms in parallel as below, and connect each set to one channel of the amp as a 4-ohm load.

-------------
Support the12volt.com

Print Page | Close Window