remote wiring
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=72485
Printed Date: October 31, 2025 at 10:37 AM
Topic: remote wiring
Posted By: cunderdown
Subject: remote wiring
Date Posted: February 09, 2006 at 3:09 AM
I wired up my amp to my sub and connected the remote wire to the back of the headunit, but when i turn of the ignition my amp stays on. I think i wired it up properly it was to plugs straight into the back of the the headunit. Ive got a citroen saxo 1998 and a kenwood headunit. cheers Craig
Replies:
Posted By: geepherder
Date Posted: February 09, 2006 at 10:17 PM
The remote wire run to the amp should be connected to the Kenwood's blue/white wire, which will switch on and off with the radio. Note that on some lower end Kenwood decks, this wire is actually a dummy wire and you use the blue wire instead.
-------------
My ex once told me I have a perfect face for radio.
|