wirring RF amp and subs

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=75066
Printed Date: May 28, 2024 at 10:47 PM

Topic: wirring RF amp and subs

Posted By: s0c0m_freak
Subject: wirring RF amp and subs
Date Posted: March 25, 2006 at 11:29 AM

hi

so Ive got a RF p3001 amp and two RF P110s4 subs. I know that im going to be running them parralel but the amp is confusing me. Its supposed to be a one channel amp, but on the side of it there are two channels. theres a "speaker A" and a "speaker B". My question is, should I wire the subs to A? Do I even need to run them parralel? could i just run each sub to its own channel?!

also would a 8 guage power cable work?

thanks a lot

Replies:

Posted By: Velocity Motors
Date Posted: March 25, 2006 at 11:44 AM

Only use one pair of the speaker outputs ( either A or B but not both ). It's a mono set up so each of the outputs is the same on monoblock amps.

Use this diagram for a 2 ohm load on the amplifier:

Use this diagram for an 8 ohm load on the amplifier:

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: s0c0m_freak
Date Posted: March 25, 2006 at 12:13 PM

Thank you very much.

Print Page | Close Window