Profile HA1040 amplifier?

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=76620
Printed Date: May 20, 2025 at 1:43 PM

Topic: Profile HA1040 amplifier?

Posted By: mep7851
Subject: Profile HA1040 amplifier?
Date Posted: April 22, 2006 at 12:52 PM

I have a 80watt x 4 Profile HA1040 amp and a set of polk 5 1/4 component speakers I am going to put in my truck. I was thinking about also adding a 10 inch sub to the system. Is it possible to use 2 of the amps channels to run the 5 1/4 speakers and bridge the remaining 2 channels for the sub?

Thanks

Replies:

Posted By: DYohn
Date Posted: April 22, 2006 at 1:02 PM

Yes it is a common installation method. Be sure your subwoofer is at least 4-ohms impedance for bridging that amp. Channels 1-2 have a high-pass filter and 3-4 have a low-pass filter on your amp, which means 1-2 are designed for your mains and 3-4 are designed for a subwoofer. Be sure to activate both filters and set them to the same frequency (probably about 100-120Hz for your 5-1/4" mains.)

-------------
Support the12volt.com

Posted By: mep7851
Date Posted: April 22, 2006 at 1:06 PM

advice that is excellent, fast, and free. Doesn't get much better than that.

Print Page | Close Window