Running power wire to 2 amps
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=77118
Printed Date: April 27, 2024 at 3:24 PM
Topic: Running power wire to 2 amps
Posted By: sab0276
Subject: Running power wire to 2 amps
Date Posted: May 01, 2006 at 4:28 PM
I have 2 amps that are going to be mounted next to each other. Can I run 1 thick power wire from the battery back to where the amps are and then split the wire from there? Or do I really have to run 2 seperate power wires directly from the battery back to each amp seperately?
The amps are a RF Punch 160.4 for the front and rear speakers, and a JBL GTQ400 for the subs.
Thanks.
-Scott
-------------
2002 GMC Yukon SLT non-Bose
Pioneer AVIC N3
Replies:
Posted By: xtremej
Date Posted: May 01, 2006 at 4:36 PM
Run larger gauge wire back and use a distribution block to split the power to the amps. What are the rms outputs of your amps?
-------------
Posted By: aznboi3644
Date Posted: May 01, 2006 at 5:22 PM
Run atleast a 4 gauge power wire to a distribution block.
Also a ground distribution block will make things simpler.
Posted By: sab0276
Date Posted: May 01, 2006 at 9:11 PM
RMS 75Wx4 for the JBL and 20Wx4 for the RF. -Scott ------------- 2002 GMC Yukon SLT non-Bose
Pioneer AVIC N3
Posted By: stevdart
Date Posted: May 01, 2006 at 10:28 PM
A distro block takes the place of splitting a large wire into two smaller wires and installing fuse holders in each of the smaller wires. It's much simpler and way neater. You can find a wide variety of fused distribution blocks.
-------------
Build the box so that it performs well in the worst case scenario and, in return, it will reward you at all times.
Posted By: danny boy
Date Posted: May 16, 2006 at 7:55 AM
can u run 1 wire from batt to amp (A) and earth amp (A) to desired location n run amp (B) of amp (A)
-------------
CRZYVS
Posted By: aznboi3644
Date Posted: May 16, 2006 at 10:04 PM
danny boy wrote:
can u run 1 wire from batt to amp (A) and earth amp (A) to desired location n run amp (B) of amp (A)
huh?
Posted By: aznboi3644
Date Posted: May 16, 2006 at 10:04 PM
danny boy wrote:
can u run 1 wire from batt to amp (A) and earth amp (A) to desired location n run amp (B) of amp (A)
huh?
Posted By: aznboi3644
Date Posted: May 16, 2006 at 10:05 PM
danny boy wrote:
can u run 1 wire from batt to amp (A) and earth amp (A) to desired location n run amp (B) of amp (A)
huh?
|