hi to all i am after some information about how to connect my subs to my amp..i have a infinity d-class mono sub amp and 2 12 inch alpine type s subs.. does anbody no wat the wire configeration is for connecting them?? What is the best ohm to set it at and how is this acheived?? thanks any help appreciated
-------------
CRZYVS
Look at the specs of your subs; at the actual voice coil configuration. These would probably be one of three different configurations: Single voice coil (SVC) 4 ohm, dual voice coil (DVC) 4 ohm, or DVC 2 ohm. When you have found what these are, look at the woofer wiring wizard in the left column help section under Car Audio. Generally, if it is possible, a final 2 ohm load is chosen for use with a sub mono amp. Do not use a 1 ohm load, but you can use a 4 ohm load.
-------------
Build the box so that it performs well in the worst case scenario and, in return, it will reward you at all times.
thanks mate il do that and see how i go
-------------
CRZYVS
it wired like the diagram but the amp protects when u increase the volume
-------------
CRZYVS
it it pos from amp to pos on sub and neg from amp to neg from sub the on sub pos to neg
-------------
CRZYVS
Wow. You Aussies can do a lot in 3 minutes, eh?
So, don't leave us in suspense. What configuration of coils do these subs have? What wiring diagram is used? Is it verified by a second look?
edit: right click the diagram you used and copy it to this reply box.
-------------
Build the box so that it performs well in the worst case scenario and, in return, it will reward you at all times.
Sounds like you have the ohm load too low. Post the specs of the subs and amp.
-------------
'85 Toy