Cut/Splice XM SkyFi2 antenna wire?

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=77701
Printed Date: May 14, 2025 at 1:58 PM

Topic: Cut/Splice XM SkyFi2 antenna wire?

Posted By: Black Dak
Subject: Cut/Splice XM SkyFi2 antenna wire?
Date Posted: May 12, 2006 at 11:10 PM

I am installing a plug in my center console (fiberglass project) so that all the electronics mounted in the console can be quickly disconnected for console removal. One of the components in the console is an XM SkyFi2 unit, and one of the wires I'd like to add to the plug is the antenna.

Can this be cut and spliced without effecting operation? It's a round wire, but is there two lines inside?

Anyone ever had to do something like this?

Replies:

Posted By: sk8ingsmurf
Date Posted: May 12, 2006 at 11:23 PM

I would not recommend cutting it, theres more than one wire inside (just two though I think) but Ive never heard of good results with trying to splice these. My recommendation would be to go buy an extension (bestbuy and radio shack should both have them) and use that as your point to disconnect.

Posted By: Black Dak
Date Posted: May 12, 2006 at 11:53 PM

I didn't know that extensions were available, I'll look into that. Thanks!

Posted By: johnmax
Date Posted: May 13, 2006 at 12:19 AM

Yeah iffy if you are trying to extend it. But to repair and not change the length is not a problem.

Posted By: Black Dak
Date Posted: May 13, 2006 at 12:23 AM

I wasn't planning on changing the length, although it's not an RF antenna, so length shouldn't matter anyway, right? I want to run it through a plug I am installing.

Print Page | Close Window