Mounting A Remote Switch

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=77994
Printed Date: May 13, 2025 at 9:39 PM

Topic: Mounting A Remote Switch

Posted By: toxicnoise
Subject: Mounting A Remote Switch
Date Posted: May 18, 2006 at 7:39 PM

I have installed many remote switches for amps in the past but today I ran accross a problem, and I was hoping you could help me out. Heres the situation, I have a toggle switch with three terminals. I ran a power wire to the battery and placed it on the power terminal. I ran a ground to the frame and placed it on the ground terminal. Now the part I dont under stand, I spliced the remote wire together and placed it on the accesory terminal but the amp doesnt kick off. The light on the switch goes on and off but not the amp. Any suggestions, thanks.

Replies:

Posted By: bcordell
Date Posted: May 18, 2006 at 10:05 PM

When you spliced the remote wire did you put both ends on the same terminal? If you did then the toggle isnt going to break the connection.

Posted By: xtremej
Date Posted: May 19, 2006 at 8:00 AM

If you want it lighted (when on) try hooking the side from the deck to the power input and the side from the amp to the accesory. ground to ground. I believe its just an led so it should be fine.

-------------