i am having problems with my planet audio zx4002 amp it hits hard when the volume is turn like to 15 but when i crank it up the bass keeps cutting out like its staggering for power. i just went and bought 4 gauge power wire to see if that would fix it but it didnt..............i am running two 4ohm 12's and the subs can handle 1200watts max and im only running 400 to ea in bridged mode and they are single voice coil......i looked at the wireing though out the car and nothin is groundin to the chassis but i still cant find the problem............the amp also has this 180degree phase controll and some kinda volt button and a sensativity controll.........it might be set wrong???? i tried messing with the setting's but the bass still keeps cutting out when i crank it up.......................any ideas ????
-------------
w0rm
First of all, that amp can only be bridged into a 4-ohm load or higher. If you have the 2 subs connected in parallel, you are placing too low an impedance load on the amp. Connect one sub to each channel and re-set your gain properly.
-------------
Support the12volt.comExactly, you are asking the amp to do something it was not designed to do. End result is that the amp is going into protection instead of blowing up on you. Rewire the subs, one to each channel.
-------------
Top Secret, I can tell you but then my wife will kill me.
THANK YOU i just got back in from doin wat u said and IT WORKED!!!!!...................... tomarrow i am goin to be installing another amp and two more 12's..............and i was wondering if i could do this and not have any problems............the other amp i have is a MTX THUNDER 4202 with a pure N-CHANNEL design the subs that i want to install are also 4ohm's...........so as long as i hook it up right i should not any any problems rite ???? if i cannot do this or should hook it up a certin way please let me know.................thanks again for helping me :)
-------------
w0rm
i had this problem too...
rewired the subs from bridged parrallel to single channels. is working fine now.
but... my problem now is that - when the balance is centered ... subs have no power - changing to left only or right only - then subs are loud and is all good. why is that ? where should i start looking ?
kicker amp - kx650.4
2x cadence subs z10w-2
any help appreciated. thnks
Go to one of the subs and switch the speaker leads (positive and negative)- you have one of them wired backwards and it's cancelling out the other one.
-------------
My ex once told me I have a perfect face for radio.
still having problem's setting my amp up.........i got this phase setting from 0-180degree's .........and a button that i have know clue wat for and a sensativity setting and my problem is i dont know how to set it up right...............maybe some one could tell me what these do or give me a website that would tell me........anyways thanks again for helping me
-------------
w0rm