Easy Wire Pass Through 05’ Tiburon

Hey guys just thought I'd share I'm sure some of you may already know. As most of you know the Tiburons especially the manual models leave very little room on the firewall. If you can't get a drill into a safe location to make your own pass through to gromet remove the few screws that hold the driver side inner fender wall. To the left of the battery you can see where the other wires enter from behind the fender wall, just feed your wire along those. With the inner fender loosened you can easily reach your hand up to pull your wire down along the fender to the gromet which is located about half way up toward the dash. It proved to be a lot faster and a bit safer than drilling and grometing.

P.S. you will have to turn the tires to get to a few of the screws.

This actually goes for most hyundai vehicles to the best of my knowledge. I own a 03 sonata and the same technique applies.