1994 chevy suburban with 6 speakers
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=78690
Printed Date: May 15, 2025 at 5:20 AM
Topic: 1994 chevy suburban with 6 speakers
Posted By: eclipser6
Subject: 1994 chevy suburban with 6 speakers
Date Posted: June 04, 2006 at 10:45 AM
my uncle bought a 94 chevy suburban and we started replacing all the audio, it has 4x6's in the dash, 6.5's in the rear doors and 4x10's in the rear . i got all the 4x6 and 4x10 ran to a 4 channel amp and it sounds wonderful but my question is can a run them 6.5 to that same amp or should i run another amp. and how does chevy have them wired in from factory to run off the factory deck and brain. thanks
Replies:
Posted By: duct tape
Date Posted: June 04, 2006 at 3:17 PM
if i recall, the 6.5s in the doors need to be rewired. there is a factory amp powering them.
Posted By: oman76
Date Posted: June 07, 2006 at 1:18 AM
The 6.5s in the rear doors are powered by a factory amp. If your 4ch. amp can handle 2 Ohm stereo load, then you can wire the rear speakers to it.
-------------
Alpine 7903/Kove Aphex Signal Processor/
Streetwires/MTX Blue Thunder Pro 400X5/JL Audio XR570-CXi/Polk Audio DB Tweeters/Image Dynamics IDQ10D4 V.2
Posted By: triedit
Date Posted: July 09, 2006 at 11:40 AM
factory amp is located under driver's seat. Its a black box labeled active audio in my ride.
-------------
triedit and gave up
|