2006 porsche boxster

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=79108
Printed Date: May 13, 2025 at 11:47 AM

Topic: 2006 porsche boxster

Posted By: mistahiggs
Subject: 2006 porsche boxster
Date Posted: June 14, 2006 at 9:14 AM

Working on installing a pioneer avic-z1 in a 2006 porsche, and i was wondering if anyone out there knew of any integration problems i'm going to run into, or if someone could locate wire diagrams that would be a big help!

Replies:

Posted By: homer1
Date Posted: June 15, 2006 at 12:30 PM

CAN-BUS interface needed for VSS wire, might have fun finding an ACC source too. If you do any kind of subwoofer, do it in the c**kpit - you woun't get much output if you try to use either trunk. Like the 7" JL woofer that is sometimes use in a 3-way component set, but give them their own amp. Good luck -

-------------
Experience gained is directly proportional to the amount of equipment destroyed - break it & learn!

Posted By: Steven Kephart
Date Posted: June 15, 2006 at 12:53 PM

I recently installed an RF mod in a 04 Cerrera and found the ACC wire in the drivers kick. It was a black wire.

Posted By: Fastlearner
Date Posted: June 15, 2006 at 1:35 PM

have fun

Print Page | Close Window