Print Page | Close Window

Line Driver

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=80495
Printed Date: May 15, 2024 at 9:33 PM


Topic: Line Driver

Posted By: mtmas8
Subject: Line Driver
Date Posted: July 19, 2006 at 1:57 PM

My headunit+signal processor currently is giving out a 4V pre-amp output and i was looking into purchasing a line driver which claims to give a 10v preamp output. will this work out if my subs are on a 10v preamp and my components are on a 4v preamp or should i hae the both the same, also i would be powering 1000/1 jl audo mono amp with 10v's will that be able to handle it?

-------------
Alpine D310 HeadUnit
Alpine PHX-H701 Signal Processor
(2) JL 13W7 Subs
(2) JL 1000/1 Amps



Replies:

Posted By: DYohn
Date Posted: July 19, 2006 at 3:35 PM
It won't matter at all as long as you set each amplifier's gain properly.

-------------
Support the12volt.com



Posted By: dwarren
Date Posted: July 19, 2006 at 4:06 PM

How about the good old question, why do you feel you need one? More devices in the signal path offer more chances for the introduction of noise.



-------------



Posted By: jeffchilcott
Date Posted: July 19, 2006 at 5:39 PM
not sure on the JL's but I know almost all product will not take much more then 5-6v input.    The high end eclipse amps will take up to 8v   but I havent seen much besides that

-------------
2009 0-1000 Trunk WR 154.0DB 2009 1001+ Trunk WR
2007 USACI World Champion
2007 World Record
2006 USACI Finals 2nd Place




Print Page | Close Window