Wiring layout 95 Mercury Villager

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=81865
Printed Date: May 16, 2025 at 2:26 AM

Topic: Wiring layout 95 Mercury Villager

Posted By: myself2
Subject: Wiring layout 95 Mercury Villager
Date Posted: August 21, 2006 at 11:56 AM

Hello to all. My dilema is that I have a radio that I have to install into a 95 Mercury Villager which has a factory amp. I got the wire harness that goes along with it but noticed that only the power,ground,illumination connection can be used due to the fact of the factory amp. I was wondering if anyone could assist me in installing this from the radio plug output to the amp. Or should I just bypass the amp and run wires to the back where the outputs go to the speakers? Any info would be greatly appreciated.

Replies:

Posted By: geepherder
Date Posted: August 21, 2006 at 9:04 PM

It sounds like you got this harness: https://www.scosche.com/scosche_caraudio.aspx?ItemID=FD02B&CategoryID=78

Take it back and get this one: https://www.scosche.com/scosche_caraudio.aspx?ItemID=FDK4B&CategoryID=78

It should be a straight forward install after that. Be sure to connect the factory amp turn on lead (maybe blue or blue/white).

-------------
My ex once told me I have a perfect face for radio.

Print Page | Close Window