JL prob in a RSX-S
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=83950
Printed Date: May 01, 2024 at 6:42 PM
Topic: JL prob in a RSX-S
Posted By: branvw
Subject: JL prob in a RSX-S
Date Posted: October 10, 2006 at 9:32 AM
i have put a sealed JL - 10W1v2 sub with a JL - A1200 amp into an acura RSX-S, the car does have the bose system in, i did not install a new deck. The input for the amp cam from the rear speaker in the car, i split the wires and ran them into the input of the amp...... The system works ok but i truly expect alot more from this system it is not hitting hard at all! is the stock boose creating a problem, do i need to change the wiring? HELP!
Replies:
Posted By: DYohn
Date Posted: October 10, 2006 at 10:36 AM
The signal to your rear speakers is crossed over (high-passed) in your head unit. You need to get a signal from the factory sub. ------------- Support the12volt.com
Posted By: branvw
Date Posted: October 10, 2006 at 10:38 AM
The factory sub has 2 wires that went into it, should splice it so i have all four input wire on the amp hooked up?
Posted By: branvw
Date Posted: October 12, 2006 at 1:59 PM
are you talking about the amp that is built into the bose subwoofer?
Posted By: forbidden
Date Posted: October 12, 2006 at 2:16 PM
Yes he is. You are far better of purchasing a good LOC to integrate the factory amplified system into the new amp.
-------------
Top Secret, I can tell you but then my wife will kill me.
Posted By: integratyper934
Date Posted: October 15, 2006 at 9:11 PM
i have never had a problem using the factory rears and not getting enough bass......did you put the signals in phase if not you will cancel out the signal.
Posted By: branvw
Date Posted: October 16, 2006 at 1:12 PM
took apart the factory sub, hooked it into the JL amp..... BUMP BUMP BUMP theres your problem!!! WOW amazing, sounds great and hits VERY HARD!
|