JL 10W6V2
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=84450
Printed Date: May 13, 2024 at 6:14 PM
Topic: JL 10W6V2
Posted By: lowfront
Subject: JL 10W6V2
Date Posted: October 22, 2006 at 3:05 AM
Alright now, I'm finally doing my install tomorrow, after sitting on my stuff for over 2 months. My big question is on the sub wiring. I have a phenoix gold 400watt xenon mono amp. Now, its has to sets of positive and negetive outputs, the 10w6v2 only has one place to put the wires into the sub.
Do I run 2 sets of wires from the amp to the sub? Or just one set of wires from the amp?
Replies:
Posted By: lowfront
Date Posted: October 22, 2006 at 3:23 AM
also I'm not doing rear speakers. Should I fill the holes with damping material, or just leave the speakers in there?
Posted By: cloak559
Date Posted: October 22, 2006 at 4:19 AM
The two positive and two negative terminals on a monoblock run to the same internal hookup. Its simply for convenience that they put more than one +/- output terminal.. So you only have to run one set of wires, and it doesnt matter which terminals you connect them to.
As for your rear speaker holes. Unless your trunk is partitioned from the cabin, you dont really have to do anything with em...
-------------
'89 Mercedes-Benz 300E
Pioneer DEH-5900UB
(2)RE Audio SX 10"s
(1)US Amps MD3D
3ft^3 @ 37Hz
Blowing up in a car accident doesnt worry me, as long as I'm putting out some major dB's when I die...
Posted By: aznboi3644
Date Posted: October 22, 2006 at 12:05 PM
Actually those holes will help bass travel into the cab...but not a big noticeable difference
|