95 GMC Vandura 2500 OEM removal

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=84733
Printed Date: May 09, 2025 at 10:48 AM

Topic: 95 GMC Vandura 2500 OEM removal

Posted By: Benji999
Subject: 95 GMC Vandura 2500 OEM removal
Date Posted: October 27, 2006 at 10:33 AM

What's up everybody?? I am replacing the factory hu in a 95 gmc vandura 2500 work van. I hit a snag though, after pulling the trim panel off of the OEM radio, and extracting the screws holding the radio in, it is hung on the right (passengers) side and will not budge, the left (drivers) side slides perfectly fine. Any ideas as to what this could be? There is plenty of clearance to pull the radio.

Replies:

Posted By: doibuy
Date Posted: October 27, 2006 at 11:36 AM

There should be a bracket on the passenger side of the radio that is bolted to the center hump of the van. you have to take off the lower sections to access the 10mm bolt.

Posted By: Benji999
Date Posted: October 27, 2006 at 12:26 PM

So just pull the section out below the trim piece and search for a 10 mm bolt??

Posted By: sparkie
Date Posted: October 27, 2006 at 2:22 PM

Take the cover off over top of the engine cover. It is held in by 4 Phillips screws. Two behind the asstray cover and two at the bottom near the floor. There is a 10 mm bolt that screws into a bracket attached to the dash in front of the engine cover near the firewall. This holds the radio in and braces the back of it.

-------------
sparky

Print Page | Close Window