stereo wiring, 06 Mitsubishi raider
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=85147
Printed Date: May 17, 2024 at 5:00 PM
Topic: stereo wiring, 06 Mitsubishi raider
Posted By: shadow714
Subject: stereo wiring, 06 Mitsubishi raider
Date Posted: November 05, 2006 at 2:44 AM
PLease help. i need the wiring diagram for the stereo for my 2006 midtsubishi raider pick up truck.
-------------
shadow
Replies:
Posted By: ferretvw
Date Posted: November 05, 2006 at 10:54 AM
Radio 12v RED / black
Radio Ground black and BLACK/ lt. green
Radio Ignition (CAN data bus)
Factory Amp Turn-on (CAN data bus)
Power Antenna N/A
LF Speaker +/- dk. green - dk. GREEN/ brown
RF Speaker +/- gray - gray/brown
LR Speaker +/- dk. grn/dk. blue - dk. grn/org
RR Speaker +/- gray/dk. blue - gray/orange
-------------
2008 Scion xB
Pioneer AVIC-D3
RF 3Sixty.2 sound processor
Stock speakers (for now ;))
Posted By: shadow714
Date Posted: November 05, 2006 at 12:36 PM
THank you so much. One question though. What does (CAN data bus) mean?
-------------
shadow
Posted By: ferretvw
Date Posted: November 05, 2006 at 12:45 PM
CAN data bus means that it is a multiplexed system and many vehicle systems operate off of this system ie airbags, abs so any of those systems could potentially be attached to the same wire. normally in cases like this you have a few options one would be to just get the ignition wire from somewhere else like the ignition harness, another would be to buy the appropriate wiring harness for the vehicle (best choice IMO), both of these may have to be used in association with th existing radio so it may have to be relocated to somewhere else in the vehicle
-------------
2008 Scion xB
Pioneer AVIC-D3
RF 3Sixty.2 sound processor
Stock speakers (for now ;))
Posted By: shadow714
Date Posted: November 05, 2006 at 12:52 PM
Not a problem. I will run the ignition wire somewhere else. unfortunatly i jumped the gun and cut the stock harness off already. but im still a bit confused. what are you saying i need to be relocated somewhere else in the vehicle? i cant just cap those those 2 extra wires?
-------------
shadow
Posted By: ferretvw
Date Posted: November 05, 2006 at 2:22 PM
sometimes yes, some vehicles however need the radio in place with those wires connected in order for other systems to continue to work properly. Im not finding a harness for that vehicle from scosche or metra so Im not sure if the radio needs to stay connected or not maybe someone else will know for that particular vehicle
-------------
2008 Scion xB
Pioneer AVIC-D3
RF 3Sixty.2 sound processor
Stock speakers (for now ;))
|