Speaker wiring
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=85778
Printed Date: May 09, 2025 at 4:11 PM
Topic: Speaker wiring
Posted By: david pascale
Subject: Speaker wiring
Date Posted: November 17, 2006 at 5:21 PM
In an atempt to duplicate a work of art by fishman, I have built a door pod loaded with 1 alphasonik psw-208 8 inch drivers and kenwood 2 way 6 1/2 speakers running off the rear channel of a kenwood kfc-541. My problem is even though this sounds good is there a passive crosover availible to keep only the low frequencies to the psw-208 and still let the kenwoods recieve the full spectrom, if not how do I make one? Next my passive crossover failed in my Kfc-p605ie's in the front channel How do I find the guilty part and replace it? I bypassed the crossover and know its not the speakers they work fine.
-------------
information is the key to solving problems
Replies:
Posted By: aznboi3644
Date Posted: November 17, 2006 at 10:43 PM
https://www.the12volt.com/caraudio/cross.asp
Posted By: david pascale
Date Posted: November 28, 2006 at 6:21 PM
thank you for the input, I have already replaced the front crossover with a replacement crossover of equal quality, so i dont need to test it to find the culprit (even though i did look for it in the section you recomended and didnt find it) As for the rear speakers I am thinking of purchasing an adio pipe three way crossover to remody that little problem. thank you again.
-------------
information is the key to solving problems
|