Wiring two 12" RF Punches
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87805
Printed Date: May 18, 2024 at 9:45 PM
Topic: Wiring two 12" RF Punches
Posted By: bludytiger
Subject: Wiring two 12" RF Punches
Date Posted: December 26, 2006 at 10:48 AM
I am about to install 2 12" RF Punches (P112S4). They're 4 ohm, 300 Max Watt, 150 RMS.
If I were to install them paralelle, would the amp I need be 2 ohm 300w x 1 @ 2 ohms continuous bridged power?
Thinking about useing this Ultimate T2-1200. I'm just asking because someone told me that would underpower the subs. But from what I'v wread, thats the size of amp I'm looking for, no?
Replies:
Posted By: forbidden
Date Posted: December 26, 2006 at 12:23 PM
Yes you would wire them in parallel and yes it would indeed be a 2 ohm load. The question is do you want a good amp or not. If the answer is yes, consider the JBL CS300.1 for example or anything else for that matter over the Ultimate.
-------------
Top Secret, I can tell you but then my wife will kill me.
Posted By: bludytiger
Date Posted: December 26, 2006 at 1:37 PM
It's actualy my brother system, and he just got the amp for christmas. What I need to know is if that amp would under power the subs. If so, then only one will be installed.
Posted By: bludytiger
Date Posted: December 27, 2006 at 12:31 PM
I need to know as soon as posible if that amp will power both subs without underpowering them or if he should just put one in instead. He's constantly on my back about the answer.
Posted By: aznboi3644
Date Posted: December 27, 2006 at 12:35 PM
That amp will power those subs fine...just wire it and properly set your gain
|